Xnova 2207 Hard Line V2

What it pulls

Xnova’s own bench test, one line per prop. Drag across the chart to move the throttle; the model above follows.

What you get for $29.00

• Six KVs, 34.5 g

  From 1650KV for 6S to 2600KV for 3–4S, each weighing 34.5 g.

  Source: Xnova data list

• Wrapped rotor

  Xnova redesigned the V2 with aluminium wrapped round the whole rotor.

  Source: Xnova product page

• Freestyle and cinematic

  Xnova aims the V2 at acrobatic freestyle and cinematic flying, lists low cogging torque and smooth running, and says the motors are precisely balanced and fully tested.

  Source: Xnova product page

• Bench numbers

  On 22.2 V the 1900KV pulls 1,848 g on an HQ Ethix S5 at 47.9 A; on 25.2 V the 1650KV pulls 1,808 g on the same prop at 39.7 A.

  Source: Xnova 1650KV prop data, Xnova 1900KV prop data

What to pair it with

Our reading of Xnova’s numbers, so your build matches what the motor was tested with.

ESC

Full-throttle currents on Xnova's bench, all on an HQ Ethix S5, run from 39.7 A (1650KV, 25.2 V) to 57.5 A (2600KV, 16.8 V); the 1900KV peaks at 47.9 A on 6S. (Xnova 1650KV prop data, Xnova 1900KV prop data, Xnova 2600KV prop data)

Props

Xnova tested every KV on the HQ Ethix S5, and the 1900KV also on the HQ Ethix S4 (1,692 g at 40.2 A). Props fit the M5 shaft. (Xnova 1650KV prop data, Xnova 1800KV prop data, Xnova 1900KV prop data, Xnova 2150KV prop data, Xnova 2450KV prop data, Xnova 2600KV prop data, Xnova drawing)

Battery

6S (1650KV), 5–6S (1800KV, 1900KV), 4–5S (2150KV), 3–4S (2450KV, 2600KV). (Xnova data list)

Frame

Four M3 screws, opposite holes 16 mm apart (the 16 × 16 pattern). (Xnova drawing)

Where to buy

• NextFPV1800KV, 1900KV, 2150KV or 2450KV, same price; also in sets of four
  $29.00seen Oct 19, 2026
  Visit
• Pyrodrone1900KV, set of four
  $117.99seen Oct 19, 2026
  Visit
• Pyrodrone2150KV
  $31.99seen Oct 19, 2026
  Visit
• Unmanned Techset of four; 1650KV, 1800KV, 2450KV or 2600KV; 1650KV and 1800KV out of stock
  price on the store’s page
  Visit
• Pyrodrone1900KV; out of stock
  $31.99seen Oct 19, 2026
  Visit

Plain links, not affiliate links. Prices change; the store’s page has the current one.

Full specs

Bench data

Redrawn from Xnova’s test reports. Thrust is static pull on a bench, more than you get in flight. Power is volts × amps; efficiency is thrust divided by power.

Inside the motor

A brushless outrunner: the coils stand still in the middle and the magnets spin around them. From the top down:

• Bell. Aluminium wrapped round the whole rotor: black, with red cut edges on a six-spoke top and red rings round the bottom of the bell. (Xnova product page, Xnova product photo, Xnova top photo)
• Shaft. M5 thread, standing 14.1 mm above the bell. (Xnova drawing)
• Base. 3.2 mm thick, with four M3 holes, opposite holes 16 mm apart. (Xnova drawing)

How fast it spins

KV is the motor’s no-load speed per volt. With nothing on the shaft, the 1900KV version reaches about these speeds; a prop loads the motor and brings it down, typically to around 70–75% of these figures at full throttle.

A 14-pole rotor has 7 pole pairs, so every turn of the shaft is 7 electrical cycles, and a six-step ESC switches the phases 42 times per turn.

About the 3D model

A generic outrunner drawn from Xnova’s published sizes: the 22 × 7 mm stator, 28.1 mm bell, 19.4 mm height, 5 mm shaft and 16 mm mounting circle. Anything Xnova doesn’t publish is typical for a motor this size, and the bell’s spoked top, the base and the inside are a generic design, not this motor’s. The colours are read off the maker’s product photos. There are no logos or markings: it is our drawing, not the maker’s.

Sources

1. Xnova: NEW! Xnova 2207 freestyle hard line V2 motor series. 1650kv_1800kv_1900kv_2150_2450kv_2600kv (product page). Retrieved Oct 19, 2026.
2. Xnova: Freestyle Hard Line V2 2207 Data List for FH 07-1650 V2 to FH 07-2600 V2 (rpm per volt, no-load current, weight, battery and resistance; image on the product page). The resistance row prints no unit.. Retrieved Oct 19, 2026.
3. Xnova: Hard Line V2 2207-1650KV propeller data (image on the product page). Retrieved Oct 19, 2026.
4. Xnova: Hard Line V2 2207-1800KV propeller data (image on the product page). Retrieved Oct 19, 2026.
5. Xnova: Hard Line V2 2207-1900KV propeller data, two props (image on the product page). Retrieved Oct 19, 2026.
6. Xnova: Hard Line V2 2207-2150KV propeller data (image on the product page). Retrieved Oct 19, 2026.
7. Xnova: Hard Line V2 2207-2400KV propeller data (image on the product page). Xnova titles this sheet 2400KV; the series' only version between 2150KV and 2600KV is the FH 07-2450 V2, which the data list gives as 2450 rpm/V.. Retrieved Oct 19, 2026.
8. Xnova: Hard Line V2 2207-2600KV propeller data (image on the product page). Retrieved Oct 19, 2026.
9. Xnova: FH 2207 V2 outline drawing (image on the product page). Retrieved Oct 19, 2026.
10. Xnova: FH2207V2-1900 product photo, side view (image on the product page), used for finish. Retrieved Oct 19, 2026.
11. Xnova: FH2207V2 product photo, top view (image on the product page), used for finish. Retrieved Oct 19, 2026.