FlyFish Flash 2806.5

What it pulls

FlyFish’s own bench test, one line per prop. Drag across the chart to move the throttle; the model above follows.

What you get for $23.90

• 2.2 kg on 6S

  On FlyFishRC’s 24 V bench the 1350KV pulled 2,171.3 g at full throttle on a GF 7042, drawing 44.75 A.

  Source: FlyFishRC datasheet

• One-piece 7075 bell

  FlyFishRC’s Uni-Bell in 7075 aluminium, which it says adds crash resistance without adding weight.

  Source: FlyFishRC product page

• NMB bearings, N52SH magnets

  NMB bearings, N52SH heat-resistant magnets and copper wire rated to 220 °C.

  Source: FlyFishRC product page

• Prop seat and lead guard

  A non-slip prop seat, a thickened base and braces that protect the wire outlet.

  Source: FlyFishRC product page

What to pair it with

Our reading of FlyFish’s numbers, so your build matches what the motor was tested with.

ESC

FlyFishRC’s 10-second peaks at 24 V are 44.75 A (1350KV) and 59.97 A (1750KV), so the 1750KV needs a much bigger ESC. (FlyFishRC datasheet)

Props

At 24 V the 1350KV pulled 2,171.3 g on a GF 7042 and 2,159.2 g on an HQ J75; the 1750KV pulled 2,325.3 g and 2,357.6 g, drawing about 60 A. (FlyFishRC datasheet)

Battery

6S, as FlyFishRC tested it; it rates the motor for 4S–6S. (FlyFishRC product page, FlyFishRC datasheet)

Frame

Four M3 holes on a 19 mm circle (19 × 19 mm); the shaft takes an M5 prop nut. A hardware set comes in the box. (FlyFishRC product page, FlyFishRC datasheet)

Where to buy

• FlyFishRCthe maker’s store; same price for both KVs
  $23.90seen Oct 19, 2026
  Visit

Plain links, not affiliate links. Prices change; the store’s page has the current one.

Full specs

Bench data

Redrawn from FlyFish’s test reports. Thrust is static pull on a bench, more than you get in flight. Power is volts × amps; efficiency is thrust divided by power.

Inside the motor

A brushless outrunner: the coils stand still in the middle and the magnets spin around them. From the top down:

• Bell. One piece of 7075 aluminium (FlyFishRC’s Uni-Bell), φ34.6 mm, matte black. (FlyFishRC product page)
• Shaft. High-strength steel, 5 mm with an M5 thread, standing 14 mm above the bell. (FlyFishRC datasheet)
• Magnets. N52SH heat-resistant magnets. (FlyFishRC product page)
• Winding. Copper wire rated to 220 °C; 20 AWG leads, 250 mm. (FlyFishRC product page)
• Bearings. NMB. (FlyFishRC product page)
• Base. Thickened, with braces protecting the wire outlet and four M3 holes on a 19 mm circle. (FlyFishRC product page)

How fast it spins

KV is the motor’s no-load speed per volt. With nothing on the shaft, the 1350KV version reaches about these speeds; a prop loads the motor and brings it down, typically to around 70–75% of these figures at full throttle.

A 14-pole rotor has 7 pole pairs, so every turn of the shaft is 7 electrical cycles, and a six-step ESC switches the phases 42 times per turn.

About the 3D model

A generic outrunner drawn from FlyFish’s published sizes: the 28 × 6.5 mm stator, 34.6 mm bell, 19.5 mm height, 5 mm shaft, 19 mm mounting circle and 12 teeth and 14 magnets. Anything FlyFish doesn’t publish is typical for a motor this size, and the bell’s spoked top, the base and the inside are a generic design, not this motor’s. The colours are read off the maker’s product photos. There are no logos or markings: it is our drawing, not the maker’s.

Sources

1. FlyFishRC: Flash 2806.5 1350KV 1750KV FPV Long Range Black Motor (product page on FlyFishRC’s store). Retrieved Oct 19, 2026.
2. FlyFishRC: Flash 2806.5 Motor (Black) datasheet: spec table, product drawing and test report for both KVs at 24 V (image on the product page). The 1750KV HQ J75 table’s 50% row (11035.6 g, 21.98 g/W) is an evident misprint and is left out.. Retrieved Oct 19, 2026.